
Paver sealing for Conway homes
Paver Sealing in Conway, FL
Between Conway Road and the Conway chain of lakes, pavers get a free sealing estimate when you call (689) 488-5644.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Fast, careful paver sealing in Conway
Paver sealing is available across Conway, from the Anderson Road crossroads to the streets that reach the chain of lakes. A local contractor cleans, re-sands and seals driveways, lanai floors and pool decks, and the estimate is free. Reach out at (689) 488-5644, and someone responds within 1 business day, usually much sooner.
Say your lake-side patio has gone dark in the corners and the joints feel loose underfoot. The color has dulled after a long run of sun, and a few pavers rock when stepped on. Cleaning, new sand and a sealed finish can bring the whole patio back to a single tone. A few typed lines work too, so book your free estimate and describe it.
Conway is an older, settled part of Orange County, with 5,464 homes and a median age of 42.5. Some pavers here may carry a coat that an earlier owner chose. That is a good reason to ask a contractor what is already on them. Call (689) 488-5644 with whatever you remember.

Why hire a local paver sealing contractor in Conway?
Conway homes sit close to lakes, canals and mature yards, and each of those changes how pavers wear. A local contractor asks about them first, so you can book your free estimate and get a plan shaped around your lot.
Free look at your lot
A contractor checks your Conway pavers in person and gives you a price before anything is agreed. There is no obligation.
A range to hold bids against
Orlando-area pages post $1.50 to $3.00 per square foot, with every step included. Compare every Conway bid with that.
Grip near the water
Penetrating sealer keeps traction when wet, which matters on a lakeside pool deck where feet are bare and often damp.
Plenty of time to decide
Take a few days with the estimate. You choose the finish and the date, and Conway weather can shift either one.
Get Your Free Estimate in Conway
Tell us about your pavers in Conway.
Free, no obligation

What paver problems show up most in Conway?
Dark patches where the air stays damp
Moss, lichens and algae grow on pavers mainly where shade keeps them wet. Conway has lakes and canals, and 4.7 percent of the community is water. A patio close to the shoreline or under a canopy of oaks can stay damp into the afternoon. Those spots turn green first, and they are washed with a treatment before any sealer goes on. Cutting back overhanging branches helps the surface dry faster between storms.
Sun that bleaches the color out
An Orlando paver company says Florida sun runs hard on sealer about ten months a year. A lakefront patio with no shade takes the full dose. Unsealed pavers fade, and sealed ones lose their coat in time. When the water no longer beads on the surface, the coat is spent and the pavers are ready for a fresh one. A fresh coat of sealer puts that protection back, and it keeps the red and tan from turning chalky.
Pool decks that take sun and chemicals
A Central Florida company points out that pool decks face sun plus chlorinated water all year. That is hard on any coat. A glossy film can also turn slick when wet, so an Orlando company suggests a penetrating sealer for decks. Say how often the pool is used when you ask for a quote. A non-slip additive is common on travertine around a pool, and the contractor can explain what that adds.
Sand lost to afternoon storms
Conway's wet season opens near May 24, with about 61 percent of the year's rain still to come. Storms usually build in the late afternoon. Loose joint sand runs out with the water, which lets pavers rock and weeds root. Check the joints each spring and fill low ones before the rain returns. Packing the joints with polymeric sand and sealing over them keeps the rain from carrying it off.
Rust lines from irrigation
According to University of Florida extension, iron is high in most Florida well water. Irrigation water with iron leaves orange streaks on whatever it hits. Look near sprinkler heads along the drive and by the lanai. The contractor treats rust first, because a coat over it would fix the stain in place. If the stain is old, the contractor may need a second pass, so ask at the estimate.
Is paver sealing different in Conway than in the lake communities next door?
Slightly, because Conway's streets run both to the lakes and away from them. Lots near the chain deal with damp shade and algae more often, while lots farther inland deal more with sun and sprinkler stains. Either way, a quick look at the lot settles what to expect. Say which side of the water you are on when you book your free estimate.
The area has deep roots. It was settled in the 1850s, and the brick Conway Road once linked it to Orlando along what is now Briercliff Drive, Curry Ford Road and Conway Road. Anderson Road was the center of town. If your home sits near that old crossroads, call (689) 488-5644 and mention the nearest cross street.
The 2020 census found that 51.8 percent of Conway households were married couples, and 17.3 percent of residents were 65 or older. Many of these homeowners plan work around their own routine and want a firm start and finish time. Ask for that in writing, then book your free estimate to set a date that suits you.
What does paver sealing cost in Conway?
Across the Orlando area the posted range is $1.50 to $3.00 per square foot, wash and sealer included. A Conway pool deck falls toward the top of that range, while a plain driveway lands lower. Algae, rust and old failing coats add washing time. To get a figure for your pavers, book your free estimate.
A bigger layout raises the total even at the same rate, so a long drive plus a lanai and a pool deck adds up. A sealer stripped from an earlier job adds cost too. Call (689) 488-5644 and ask the contractor to list every extra before work begins, so the price on the day matches the quote.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Small patio or walkway | $450 to $900 |
| 600 sq ft | Two car driveway | $900 to $1,800 |
| 1,000 sq ft | Large driveway or pool deck | $1,500 to $3,000 |
| 1,500 sq ft | Driveway plus pool deck | $2,250 to $4,500 |
Math based on the $1.50 to $3.00 per square foot that Central Florida paver companies published as of November 2026. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.

How does a paver sealing job work in Conway?
Check the pavers, the drainage and the shoreline side
The contractor walks the lot and looks at how water leaves the pavers. Sunken spots are marked, since a coat would keep a dip. Shaded and lakeside corners are checked for algae. Any earlier sealer is identified, because water-based product cannot go over solvent-based. Say which side of the house gets the least sun. Photos of your pavers help if you want a rough read before the visit.
Treat the algae and wash the surface
Green film gets a treatment before the wash. Washing then lifts dirt, rust and oil. Cleaner stays out of the pool and off the screens, and plants are rinsed. The pavers are left to dry afterward, since sealer needs a clean, dry surface to bond. Shaded spots take longer. On a pool deck, the contractor also checks that drains stay clear during the wash.
Refill the joints
Washing pulls sand out, so fresh sand goes back in. The joints are filled and swept until they sit snug. Packed joints keep pavers from rocking and give weeds less room. If you have seen pavers shift when you step, mention which ones. A joint that holds sand firmly also resists the ants and weeds that move into gaps.
Pick a finish for the spot
Penetrating sealer keeps a matte look and traction when wet, which suits a pool deck. Film-forming sealer deepens color and shows scuffs sooner. A driveway can take either. The contractor can test both on a corner so you see the difference before choosing. Ask to see the finish on a small patch, and take your time choosing.
Seal in thin coats on a dry day
The coat goes on thin and even, and it is worked into the joints. The contractor watches the sky, since rain in the forecast can turn sealer white. Most quotes you hear will put the next coat two to five years out. Expect to keep off the surface for a day or more. Furniture usually stays off until the next day, and sprinklers wait until the coat has cured.
Complete paver services in Conway
A Conway job follows one order: treat the algae, wash, refill the joints, let the surface dry, then seal. The coat comes last so nothing dirty gets trapped. Lakeside shade can slow the drying stage, so ask how long yours takes. Call (689) 488-5644 to hear how the contractor would schedule it.
Pool decks and lanai floors in Conway get constant moisture and sun. Driveways get tires and the occasional boat trailer. Entry walks get steady foot traffic. Choose book your free estimate, name the surfaces that matter most, and the sealer choice can follow.
Penetrating sealer suits wet areas, because it keeps traction and a matte look. Wet look suits driveways where you want deeper color. A water-based coat cannot go over solvent-based sealer, so the old product matters. Ring (689) 488-5644 and ask which finish fits your Conway home.
Dry weather helps a sealing job more than anything else. The wet season starts in late May and storms build late in the day, so mornings are favored. Fall brings drier air as October cold fronts arrive. Ask which days are free on your street when you book your free estimate.
Questions to ask before you hire
- Do you price by the square foot or by the job, and is the estimate free?
- Will you reset any pavers that have sunk before you seal?
- What do you do about the weeds and moss growing up through my joints?
- Can you send proof of insurance before anyone shows up at my house?
- Will the sealer leave a wet look, a satin look or a matte look?
- Does an afternoon thunderstorm change your schedule on the day of the job?
- What happens if the sealer peels or turns cloudy after a few months?
What do sealed pavers look like around Conway?









Why local matters in Conway
A contractor who works around the Conway chain of lakes knows how damp air and shade build up on shoreline patios. That shapes how the algae is treated and how long drying takes. Someone from another county may not plan for it. A quick phone talk often shows what the work will involve, so call (689) 488-5644.
Local timing matters too. Afternoon storms are routine from late May, so a good crew starts early and stops when clouds build. A date can slide a day or two without hurting the result. To learn how rescheduling works, book your free estimate.
Conway pools and lanais call for care with cleaner and overspray. A local contractor knows to cover screens, rinse plants and keep runoff out of the water. If you have a pool, mention it when you call (689) 488-5644, and the plan will account for it. Small habits like that protect your plants and your pool.
Why does Conway's lake history matter to a paver owner?
It explains why the lakes are where they are. Native peoples called the area Okehitanatchee, meaning land of fair waters, and a surveyor named Lake Conway in 1843. Seasonal rains once joined the whole chain into one lake. If you live near Hoffner Avenue or Nela Avenue, book your free estimate and mention it.
The chain now covers nearly 1,800 acres of surface water, with parks such as Venetian Park, Swann Beach and Trimble Park along the shore. The Randolph Boat Ramp sits where Crittenden's Dock stood in 1882. In the late 1950s a state law created a district to look after the lake. When one of these spots is near you, call (689) 488-5644 and say which street.
Frequently Asked Questions
How long does paver sealing last in Conway?
Companies commonly quote a recoat every two to five years in Conway. An Orlando paver company lists 3 to 5 years for natural finishes and 2 to 3 for gloss finishes and pool decks. Full sun on a lakeside patio pushes a Conway job toward the short end. A water test tells you: if it beads, the coat still works.
Is it better to spray or roll paver sealer in Conway?
Using both is common. An Orlando company describes thin coats put on with a low-pressure sprayer and then back-rolled into the joints. The spray covers fast and the roller evens it out. Ask the contractor how your Conway surface will be done.
What happens to unsealed pavers beside the Conway lakes?
Their color fades, stains soak in and joint sand is lost earlier. Algae and mildew take hold where damp shade lingers, and weeds root in joints that have opened. Sealed surfaces are less prone to mold and mildew. Sealing slows the wear without stopping it.
How much is paver sealing in Conway?
Orlando-area companies post between $1.50 and $3.00 per square foot for everything. A pool deck often sits near the top of that range. Algae, rust and old failing sealer raise a Conway quote. A free estimate gives the real total.
Which sealer is best for a pool deck in Conway?
A penetrating sealer is the usual pick for a pool deck. It soaks in, keeps a matte look and holds traction when wet. A glossy film can be slick underfoot. Ask the contractor to confirm the product suits wet, bare feet.
How often do you seal pavers in Conway, Florida?
Most Conway owners reseal every two to five years. Pool decks, gloss finishes and busy driveways wear sooner than a shaded walkway. Check in spring, and book before the wet season if water soaks in. The contractor can test your pavers.
Is sealing pavers a good idea near the Conway lakes?
Yes, in most cases. Damp air and shade near the water favor algae, and sealing makes surfaces less prone to mold and mildew. It also holds joint sand against storms. The trade is upkeep, since the coat wears and needs redoing.
Can I seal pavers in Conway during the wet season?
You can, on a dry day. The surface has to be fully dry, and rain in the forecast can turn sealer white or make it peel. The wet season runs roughly late May through mid-October. Many Conway jobs land in the drier months for that reason.
What does a pool deck sealing job in Conway involve?
It starts with a wash and an algae treatment, then fresh joint sand and a penetrating sealer that keeps traction. Cleaner and overspray are kept out of the pool and off the screens. Ask how long you must keep the deck dry and free of traffic afterward.
Will sealing stop algae on my Conway pavers?
It slows algae, though it does not end it. Sealed surfaces are less prone to mold and mildew, and the coat keeps the pavers from soaking up damp. Heavy shade still needs a wash now and then. The contractor can tell you how often yours might need one.
How soon can I use my Conway pool deck after sealing?
Foot traffic usually waits at least 24 to 48 hours, and an Orlando company puts vehicles at about 72 hours. A pool deck in shade or humid air can take longer to cure. Keep furniture and wet feet off until the contractor says the coat is set. Ask for a firm time before the day begins.
Do I need to re-sand my Conway pavers before sealing?
Yes, in almost every case. The wash empties the joints, so new sand is packed in ahead of the coat. Skip it, and one Orlando company warns the joints will wash out in the first hard rain. Packed joints also keep pavers from rocking underfoot.
Ready for a Free Estimate in Conway?
Call (689) 488-5644 and tell us about your pavers.
Free, no obligation
