
Clear off the green and top up every joint
Paver Cleaning and Joint Sand in Winter Park, FL
Dial (689) 488-5644 for a free estimate to clean and re-sand your Winter Park pavers.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can I get my pavers cleaned in Winter Park without a long wait?
A local contractor cleans pavers across Winter Park, FL, and you will hear back within 1 business day, usually much sooner. New joint sand is part of the job, and the free estimate carries no pressure to book. To start, call (689) 488-5644.
Cleaning lifts the algae, mildew, leaf marks and grime that dull pavers in oak shade, so the surface looks brighter and grips better underfoot. Fresh sand is then swept into every joint to keep the pavers from shifting and to leave weeds little room. The courtyard that went dark over the summer can match the rest of the yard again. Point out the worst spots when you book your free estimate.
Paver Sealing Winter Park Is Proud to Serve Central Florida

What is part of a paver cleaning job?
Expect stain and algae treatment, a low pressure wash and new joint sand once everything dries. You can order it by itself or as the opening stage of sealing. Shaded courtyards, lakeside patios and spots near sprinkler heads usually take the most time. To line up a cleaning, call (689) 488-5644.
Algae and stain treatment
A cleaner matched to the problem goes on first, and the contractor tries it on a small spot.
Low pressure wash
A surface cleaner gives an even pass at a pressure that leaves the joints in place.
Fresh joint sand
Dry sand is swept into every gap after the pavers dry, then settled in.
Sealer if you want it
If you want a coat, it goes on after the pavers have dried completely. The sealing guide covers what it adds.
What are the signs my pavers need cleaning?
Signs include a green or black film along shady edges, dark streaks after the rainy season, weeds in the joints and sand on the drive after a storm. Algae matters most of these, since a slippery walkway or pool deck is where people fall. To have yours looked at, call (689) 488-5644.
Is cleaning enough, or should I seal my pavers too?
Washing changes how the pavers look this week, and a coat decides how long they stay that way. Stopping at the wash costs less up front, but algae and fading return on their own schedule. A coat makes later washes easier and needs renewing every two to four years. Say which you want when you book your free estimate.
How often should Winter Park pavers be cleaned?
Paver Sealing Orlando suggests a maintenance cleaning every 12 to 15 months, which also stretches the life of a coat. The National Weather Service puts the typical start of Orlando's dry season near October 15, so a wash in the fall clears a summer of growth. Shady courtyards may need attention sooner than a sunny driveway. To set a schedule, call (689) 488-5644.
Does more pressure clean pavers better?
No. Western Interlock, a paver maker, says to keep pressure under 1,500 PSI and the nozzle at least 6 inches away, and it warns that pressure washing can lift joint sand and disturb sealer. A hard blast can also etch softer pavers. Ask what pressure the contractor plans to use when you book your free estimate.
Method matters as much as the machine. A surface cleaner held about an inch from the paver, the distance Western Interlock gives, washes evenly, and a cleaner matched to each stain does the heavy work. Ask where the runoff goes, too, if your yard slopes toward a lake or canal. To ask those questions now, call (689) 488-5644.
Why does green growth keep coming back on Winter Park pavers?
Shade and moisture. Olde Winter Park's small brick streets sit under live oak and camphor trees, and the National Weather Service says summer afternoons build into storms across Central Florida. Damp, shaded pavers grow algae. A cleaning after the rainy season ends starts you off clean, and sealing helps the surface dry and rinse. To plan a visit, call (689) 488-5644.
What is the white film on my newer pavers?
White haze on newer pavers is most often efflorescence, which is salt moving up out of the concrete. Unilock says it typically takes two to three months to clear, and sealing should wait until it is gone. Western Interlock treats it with a diluted acid rinsed off within three minutes. Clouded old sealer can look similar, which is worth a mention when you book your free estimate.
Which paved areas at a Winter Park home can be cleaned?
Any paved spot at the house can be washed, whether it is the driveway, the pool deck, a courtyard or the front walk. Each one gathers its own kind of dirt, which changes the cleaner and the method. To start with yours, book your free estimate.
Driveways
Tires and oil drips hit the driveway first, and the open stretch gets the most sun. Cleaning here keeps color even and the joints full under the wheels.
Pool decks and lanais
Chlorinated water, constant moisture and sun are hard on a pool deck, according to Castle Clean and Seal. Cleaning around the water should still leave bare feet on a surface with grip.
Patios and courtyards
A courtyard under oak branches stays damp long after the rest of the yard dries. Cleaning there is mostly about getting the green out of the corners.
Walkways and entries
The front walk is narrow and sits beside beds, mulch and sprinklers. Cleaning at the entry is a small job that every guest sees.
What leaves Winter Park pavers dirty?
Oak shade, storm sand loss, leaf litter, pool wear and sun fading lead the list. Washing clears some of these, while sealing or repairs deal with the others. Call (689) 488-5644 to find out which of these your home has.
1. Green growth in oak shade
The city is known for its tree canopy, and Olde Winter Park's winding brick streets sit under live oak and camphor trees. Shade keeps pavers damp, and damp pavers grow algae.
2. Sand lost in summer storms
Afternoon cloud buildups are routine in a Central Florida summer, the National Weather Service says. Heavy rain carries sand out of the joints, and low joints let pavers shift and weeds in.
3. Leaves and litter from the trees
The city counts about 22,000 street and park oaks. Leaves left on a patio hold moisture against the surface and mark it.
4. Wear around pools
Castle Clean and Seal calls chlorinated water, constant moisture and sun a harsh mix for pool decks. Color fades and edges get slick where splash water lands.
5. Fading on open driveways
An open driveway sits in direct sun from sunrise to sunset. The wash shows how much color remains, and a coat after it slows the next round of fading.
What does paver cleaning cost in Winter Park?
Orlando-area companies publish one price for the full clean, sand and seal, $1.50 to $3.00 per square foot, and wash-only work is quoted per job after a visit. Castle Clean and Seal sets a $1,000 project minimum on its Central Florida jobs. Condition moves the number, since weeds, algae and efflorescence add prep. For a price on your property, book your free estimate.
If you plan to seal as well, ask for one combined price and for the sand to be listed on its own line. At the published range, a 600 square foot driveway comes to about $900 to $1,800. To compare a quote you have, call (689) 488-5644.
If protection matters too, read about sealing your pavers or browse the towns on the list, or return to Winter Park paver sealing.
| Paved area | Typical example | Full clean, sand and seal |
|---|---|---|
| 400 sq ft | Patio and walkway | $600 to $1,200 |
| 800 sq ft | Wide two car driveway | $1,200 to $2,400 |
| 1,200 sq ft | Driveway and entry | $1,800 to $3,600 |
This table uses the $1.50 to $3.00 per square foot that Central Florida paver companies published as of November 2026. Orlando-area companies post the combined price, and washing alone is usually quoted per job after a visit. Larger areas often cost less per foot, so your own quote can land above or below these figures.

Why use a local contractor for paver cleaning?
A contractor who works around Winter Park knows what oak shade, leaf litter and lake humidity leave behind. Compare any quote with the rates published on this page, and take the time you need to decide. To begin, book your free estimate.
Contractors who know the area
A company that works in and around Winter Park already deals with oak shade, lake humidity and summer storms. That makes the first visit more useful.
Free to ask
The visit and the estimate cost nothing. If the number does not suit you, you can say no and owe nothing.
Prices you can check
Central Florida companies publish what they charge per square foot, and this site shows that range. A bid far above or below it deserves a question.
You set the pace
Ask for the price on paper, then take as long as you like to decide. Before signing, read the contractor standards page for the points worth confirming.
Want a free estimate to clean your Winter Park pavers?
Use the short form or phone, and a contractor responds within 1 business day, usually much sooner.
Free, no obligation

What do cleaned pavers look like around Winter Park?








How does the paver cleaning process go, step by step?
If no sealer is ordered, the visit stops after the joints are refilled in step three. To set a date, call (689) 488-5644.
1. Measure and inspect
Before quoting the cleaning job, the contractor measures the paved area and writes down sunken pavers, broken edges, old sealer and any pooling water.
2. Protect and wash
Plants, screens and doors get covered and the sprinklers go off. An algaecide goes on, then a low pressure wash cleans the surface without emptying the joints.
3. Refill the joints
After the pavers dry, fresh sand is swept in and settled, and the extra is cleared off the top.
4. Let it dry, then seal
Sealer goes on a fully dry surface. A pump sprayer lays it down and a dry roller takes up the excess, the method Unilock describes.
5. Walk the job
The contractor walks the area with you and says how long to keep feet, furniture and cars off. You also hear when to expect the next coat.
Frequently Asked Questions
How do you get pavers clean?
A contractor treats algae and stains first, then washes at low pressure and sweeps fresh sand into the joints once the surface dries. Western Interlock, a paver maker, says to keep pressure under 1,500 PSI, and it calls a bleach rinse the way to deal with algae. Ask what the contractor uses near plants and pool water.
How much does it cost to clean pavers?
Orlando-area companies publish the combined clean, sand and seal price, which is $1.50 to $3.00 per square foot, and wash-only work is quoted per job after a visit. Castle Clean and Seal sets a $1,000 project minimum. Ask for the wash and the sand listed apart so you can compare.
What is the right cleaner for driveway pavers?
It depends on the stain. Western Interlock calls a bleach rinse the way to deal with algae and uses an oil extractor on oil. Efflorescence takes a diluted acid rinsed off within three minutes. A contractor matches the cleaner to the stain and tests a small spot first.
What not to use to clean pavers?
Skip high pressure and close nozzles. Western Interlock says to stay under 1,500 PSI and keep a pressure wand at least 6 inches from the surface. Leaving acid on the surface is also a mistake, since its guide says to rinse it off within three minutes.
Is it a good idea to pressure wash pavers?
Yes, when the pressure stays low and the joints get fresh sand afterward. Western Interlock warns that pressure washing can lift joint sand and disturb sealer. A surface cleaner held an inch from the paver gives a more even wash than a wand.
Should you seal pavers after power washing?
Not required, but dry joints need new sand either way. Sealing after the sand goes in helps hold it through the next storm. The surface has to be fully dry before any coat goes down.
How much does it cost to have pavers cleaned and sealed?
For the whole job, expect companies in the Orlando area to publish $1.50 to $3.00 per square foot. A 600 square foot Winter Park driveway comes to about $900 to $1,800. Failed sealer that has to be stripped usually adds $500 to $1,000 or more, according to Castle Clean and Seal.
Why do my Winter Park pavers turn green under the oaks?
Shade keeps the surface damp, and algae grows on damp pavers. Olde Winter Park's brick streets sit under live oak and camphor shade, and many yards do too. Sealing helps the surface dry faster and rinse clean.
How often should I clean pavers in Winter Park?
One Orlando paver company suggests a maintenance cleaning every 12 to 15 months, which fits a climate where afternoon storms build all summer. Shady walks may need it sooner than an open driveway.
Pick a day to freshen your Winter Park pavers
Fill in the form or ring, and a local contractor gets back to you within 1 business day, usually much sooner.
Free, no obligation
